![]() |
|
- Micro Connector System
- Micro Switch SPDT on/on
- Sub-Micro Switch SPDT on/on NEW
- Switch Harnesses and Harness Kits
- Speed Trimmer
- Micro Wires
- POLYCELL Line of Rechargeable Lithium Polymer Cells NEW
- Special Single Cell Charger for 120, 200 and 250 mAh POLYCELLS
- PLUG-IN Headers for 2 and 3 cell Series or Parallel Packs
- KOKAM Lithiujm Polymer Cells
How To Order From SKY HOOKS & RIGGING
To Process Your order (Checkout)
Available as 2-wire sets, used to connect your power supply or battery cells to the motor and to the radio system and 3-wire sets, used for all connections between radio receivers and Light Servo units.Optimized for absolute light weight, the Micro Connector System weighs 3.5g per mail/female connector set. The wire attached to the connectors weighs 0.93 g per meter.
All WES-Technik factory assembled Light Servo units come with female Micro Connectors factory installed. If you wish to use these same connectors for your radio receiver, you will need Micro Connector Male pieces (part#MCF). These come supplied with approximately 10 cm of wire attached.
The MCMB and MCFB units are of heavier wire and are intended for use with outdoor batteries and motors.
|
Connector Plug w/3-wires
|
#MCM-3
|
|
|
|
Connector Socket w/3-wires
|
#MCF-3
|
||
| Connector Plug w/2-wires | #MCM-2 | ||
| Connector Socket w/2-wires | #MCF-2 | ||
| Connector Plug w/2-wires Heavy | #MCMB | ||
|
Connector Socket w/2-wires Heavy
|
#MCFB |
Wiring Harness Kits and Complete HYBRID Switch Harnesses
![]() |
Free Flight Wiring Harness Kit
|
|
|
R/C Wiring Harness Kit
|
|
|
|
![]() |
RX72-HYBRID Switch Harness
|
|
|
|
#SMSPDT
|
|
|
![]() |
|
|
![]() |
Speed trimmer to limit climb on electric indoor free flight aircraft. |
|
|
| Super Flexible Micro Hookup Wire, 40 strands of 44 ga. copper in a thin 28 ga. skin. |
|
|
![]() |
Rechargeable 3.7 Volt Lithum Polymer Cells
Made from solid polymer electrolyte, so ther is no chance of leakage. Each cell has built-in circuitry that will protect your investment from overcharging, reverse charging and short circuiting.Circuit may be reset by connecting to a charger. |
|
|
|
|
|
|
|
| POLYCELLS and SIZES AVAILABLE All POLYCELLS come with built in protection circuitry intended to prevent short circuits, reverse charging and battery fires. All POLYCELLS are pre-soldered and fitted with pig tail output leads. | |||||
|
Product
|
Capacity
|
Weight
|
Dimensions
|
Price
|
|
| # POLYCELL-120 |
120 mAh
|
3.2 grams
|
30 mm x 20 mm x 3.2 mm
|
|
|
| # POLYCELL-200 |
200 mAh
|
5.0 grams
|
30 mm x 16 mm x 6.2 mm
|
$14.00 each Canadian | |
| # POLYCELL-250 |
250 mAh
|
5.4 grams
|
30 mm x 16 mm x 5.6 mm
|
|
|
| # POLYCELL-650 |
650 mAh
|
17.2 grams
|
62 mm x 35 mm x 3.8 mm
|
|
|
| # POLYCELL-930 |
930 mAh
|
21.8 grams
|
75 mm x 34 mm x 4.5 mm
|
$21.00 each Canadian |
|
| # POLYCELL-1600 |
1600 mAh
|
35.8 grams
|
85 mm x 50 mm x 5.2 mm
|
|
|
| # POLYCELL-3000 |
3000 mAh
|
80 grams
|
102 mm x 106 mm x 3.4 mm
|
|
|
| If the power level in a POLYCELL drops below 3 Volts, or the cell is short circuited, the result may be high heat, gassing and venting. The cell may not recover. To prevent this happening, be sure to use a Sky Hooks & Rigging SCSH-7A-V or SCSH-7A-3 speed controller or the Sky Hooks & Rigging RX72N-HYB-V narrow band, low voltage receiver, or the RX72N-HYB narrow band receiver. These are designed specifically to work with POLYCELLs and POLYCELL packs. | |||||
|
PERFECT FOR THAT SINGLE CELL LIGHT WEIGHT PLANE
Microprocessor controlled charge, this unit is very tiny and operates on any 12 tro 14 Volt DC source. Great for charging in the flying site between flights. Handles single lithium polymer cells and has a 100 mAh charge rate. Specially designed for POLYCELL-120, 200 and 250 cells. Comes Complete With:
Very Easy to Use:
Has Two Charge Status LEDs:
|
|
| HEADERS for assembling POLYCELL and KOKAM cells into Series and Parallel battery packs
Based on the standard JST connectors, these headers allow the model builder to assemble Parallel and/or Series battery packs simply by pluging the cells into the appropriate headers. At the moment, we carry headers for two and three cells per group. |
||||
![]() |
# MCM-2-SC-2 | Harness header set up for TWO CELLS in SERIES |
|
|
| # MCM-2-SC-3 | Harness header set up for THREE CELLS in SERIES |
|
||
![]() |
# MCM-2-PC-2 | Harness header set up for TWO CELLS in PARALLEL |
|
|
| # MCM-2-PC-3 | Harness header set up for THREE CELLS in PARALLEL |
|
||
|
|||||
|
Product
|
Capacity
|
Weight
|
Output Rate
|
Price
|
|
| # KOKAM-150 |
|
4.2 grams
|
4C Output
|
|
|
| # KOKAM-340SHD |
|
|
|
||
| # KOKAM-340SHD-2S |
|
10-20C Output
|
|
||
| # KOKAM-340SHD-3S |
|
10-20C Output
|
|
||
| # KOKAM-640HD |
|
14 grams
|
7-10C Output
|
|
|
| # KOKAM-640HD-2S |
|
29 grams
|
7-10C Output
|
|
|
| # KOKAM-720HD |
|
7-10C Output
|
|
||
| # KOKAM-720HD-2S |
|
7-10C Output
|
|
||
| # KOKAM-720HD-3S |
|
7-10C Output
|
|
||
| # KOKAM-1250HD-2S |
|
15-30C Output
|
|
||
| # KOKAM-1250HD-3S |
|
15-30C Output
|
|
||
| # KOKAM-1500HD |
|
7-10C Output
|
|
||
| # KOKAM-1500HD-2S |
|
7-10C Output
|
|
||
| # KOKAM-1500HD-3S |
|
|
7-10C Output
|
|
|
| # KOKAM-2000 |
|
15-30C Output
|
|
||
| # KOKAM-2000-2S |
|
15-30C Output
|
|
||
| # KOKAM-2000-3S |
|
15-30C Output
|
|
||
| If the power level in a KOKAM Cell drops below 3 Volts, the result may be high heat, gassing and venting. The cell may not recover. To prevent this happening, be sure to use a Sky Hooks & Rigging SCSH-7A-V speed controller or the Sky Hooks & Rigging RX72N-HYB-V narrow band, low voltage receiver, or the RX72N-HYB narrow band receiver. These are designed specifically to work with lithium polymer cells and packs. | |||||
SKY HOOKS & RIGGING | TO PROCESS YOUR ORDER ()Checkout)
Copyright © SKY HOOKS & RIGGING 1998. All rights reserved.
All images are copyright stamped for the protection of the originator
All sales are final unless otherwise stated.
The user must determine the suitability of all items for the intended use and assume all risk and responsibility thereof.